Insole manual: Sink

home > support > manual and faq > insole > sink

How to use sink

Time to finish: 2 minutes
Required: LutraCAD Insole software

Creating a sink can be used when you want to lower a specific area in the insole. A sink can be created by following the next steps:

sink instructions

  • Click on the icon shown below
  • Choose the sink you want to use and click on "OK"
  • Fill in the desired depth of the sink
  • The sink is now added to the designed insole
  • If required you can now reposition the sink on the insole and if necessary adjust it
  • Click on "Flow Elements" to finish the creation of the sink in the insole

How to sink using LutraCAD software

Interested in our products?

Contact LutraCAD

Privacy Policy | Copyright © 2015-2019 LutraCAD B.V.