Insole manual: Lasso

home > support > manual and faq > insole > lasso

How to use lasso

Time to finish: 2 minutes
Required: LutraCAD Insole software

The lasso function can be used to select control points and to select a specific area of the Bounding Box. It works by following the next steps

lasso instructions

  • Click on the icon shown below
  • Click and hold in the left hand mouse button
  • Circle around the point you want to select
  • Finish the selection with the right hand mouse button or by pressing enter

ATTENTION: Pressing the SHIFT-button results in points to be added to the selected area. Pressing the CONTROL-button deletes points from the selected area.

How to lasso using LutraCAD software

Related pages

Interested in our products?

Contact LutraCAD

Privacy Policy | Copyright © 2015-2019 LutraCAD B.V.